Polymer 80 Process : Practical Methods and Tips for Holes, Tabs, and Channel Removal

The%20ONLY%20Honest%20Make%20Money%20Offer%20You'll%20Find

The%20ONLY%20Honest%20Make%20Money%20Offer%20You'll%20Find

This is the way…but it’s not the ONLY way to get your Polymer 80 ready to accept parts. If this was a book I think I’d call it “the Poor Gunslinger’s Guide to a Real …

12 thoughts on “Polymer 80 Process : Practical Methods and Tips for Holes, Tabs, and Channel Removal

  1. Jazzman3121 says:

    Pretty helpful vid. Gotta keep it on the square 😉 Regarding the pistol frame build/cut part of the design and the jig, do you have a preference between the Polymer 80 and the 80 Percent Arms models?

  2. Gunnar Knutson says:

    You think you’ll change my mind on that dremel workstation no way man lol ain’t happening
    Cheap tip poor mans drill vice your knees lol i did it that why to use two hands on drill without vice I did mine perfect until I redrilled them and fucked em cuz I didn’t know the strike locking block fix

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.